Tackle3D Pellet Groove Cutters

Easy to use with a non-slip design so the pellets do not spin when you apply pressure during the groove cutting. You will save so much time with one of these in your bag of tricks. Stock up the day before you go fishing by spending half an hour cutting the grooves into the pellets. No more cutting singles on the bank with wet hands!

The two grooves that you have cut will help the band have a better grip on the pellet. This will help the pellet to stay on the band for longer, Especially when it comes to styles of fishing such as Pellet Waggler and Shallow fishing/Slapping.

I suffer with the movement in my hands and this was the main reason for creating this groove cutter. It has been a big help for me and hopefully it may help others who also suffer with stiff sore hands.

Currently we have 1 version of the cutter that will accommodate 8mm & 10mm Pellets, however, we will be looking to add more variations. You will be able cut up to 9 x 8mm and 7 x 10mm pellets at one time.

How to use the Cutter

• Open Case and insert your pellets of choice.
• Close the case. It will not close all the way and is normal.
• Apply pressure to the case, this will then allow the case to grip to the pellets.
• Take your table knife, slot it into the groove, slide it over the pellets with a little pressure.
• Then, flip the case over and repeat the process. Job done!

It may take a few tries to figure out the correct pressure and how many times you need to run the knife over for the best results. The cutter will come to 2 End Caps for use when stored away in your Box Drawers or Bags.

For myself, I use a small amount of pressure, and I run the knife over the pellets 5 times. This is what works for me with the pellets I use.

Designed & Printed in the United Kingdom to High Standards.